Type MSGK – port handling

   

Product information flyer

MSGK

Type MSGK – port handling

Applications

In seaports, inland harbours and storage yards for handling general scrap, car bodies, steel chips, shredded scrap, paving stones and much more. For harbour jetty construction and riverbed maintenance. For a wide variety of crane installations and cable excavator installations with inside or outside-running holding ropes.

Technical design

  • as 2 and 4-cable grabs, with open, semi-enclosed or enclosed jaw design
  • suitable for handling scrap, stones, refuse and other loads that are difficult to pick up, depending on the design
  • Closing cable design:
    • Cable guides
    • KRÖGER cable guide sheave system of ZERO-maintenance design with friction bearings that is kind to the cable
  • core housing with rigid bearing arrangement to accommodate the lower sheaves, smooth cable operation and low cable wear also when the crossbeam is inclined during grab operation
  • Cable sheave bearing:
    • Sliding bearing, for re-lubrication
    • KRÖGER cable sheave system of ZERO-maintenance design
  • Grab hinge bearings:
    • Steel-bush bearing which can be re-lubricated
    • KRÖGER bearing system of ZERO-maintenance design
  • rugged jaw design with jaw plates made of S355J2+N material – depending on the application with hard-wearing edge made of Pantanax round-section steel
  • welded jaw teeth of highly wear-resistant special steel

All Grapples:

Hydraulic grabs
Special grapples for alternative fuels
Lifting equipment